EMF Equation of a Transformer
Field: Power switch
China
Background of Transformer EMF Equation Derivation
When a sinusoidal voltage is applied to the transformer's primary winding, an alternating flux ϕm is induced in the iron core. This sinusoidal flux links both primary and secondary windings, with its functional form described by a sine function.
Mathematical Derivation of Flux Rate of Change
The following outlines the derivation of the transformer's EMF equation, with defined parameters:
Turn Ratio and Flux Density Relation
The above equation is referred to as the turn ratio, where K denotes the transformation ratio.
Using the relation ϕm=Bm×Ai (where Ai is the iron core cross-sectional area and Bm is the maximum flux density), Equations (8) and (9) can also be expressed as:
Give a tip and encourage the author!
Recommended
Adjustment and Precautions for H61 Oil Power 26kV Electric Transformer Tap Changers
Preparatory Work Before Adjusting the Tap Changer of H61 Oil Power 26kV Electric Transformer Apply for and issue a work permit; carefully fill out the operation ticket; conduct a simulation board operation test to ensure the operation is error-free; confirm the personnel who will carry out and supervise the operation; if load reduction is required, notify affected users in advance. Before construction, power must be disconnected to take the transformer out of service, and voltage testing must be
12/08/2025
Voltage Imbalance: Ground Fault, Open Line, or Resonance?
Single-phase grounding, line break (open-phase), and resonance can all cause three-phase voltage unbalance. Correctly distinguishing among them is essential for rapid troubleshooting.Single-Phase GroundingAlthough single-phase grounding causes three-phase voltage unbalance, the line-to-line voltage magnitude remains unchanged. It can be classified into two types: metallic grounding and non-metallic grounding. Inmetallic grounding, the faulted phase voltage drops to zero, while the other two phas
11/08/2025
Composition and Working Principle of Photovoltaic Power Generation Systems
Composition and Working Principle of Photovoltaic (PV) Power Generation SystemsA photovoltaic (PV) power generation system is primarily composed of PV modules, a controller, an inverter, batteries, and other accessories (batteries are not required for grid-connected systems). Based on whether it relies on the public power grid, PV systems are divided into off-grid and grid-connected types. Off-grid systems operate independently without relying on the utility grid. They are equipped with energy-s
10/09/2025
Transformer Use and Installation: Ensuring Safe and Reliable Operation
Operating Conditions for Transformers The installation site must be free from flooding, located at an altitude not exceeding 1,000 meters, and maintained in an ambient temperature not exceeding 40°C. Relative humidity may reach 100% within an operating temperature range of 40°C to -25°C (on-load tap changers and temperature controllers must be rated for -25°C). The installation area should be clean, free from conductive dust and corrosive gases, and equipped with sufficient natural or mechanical
09/17/2025
