Ang dead short mao ang isang electrical circuit nga nagresulta og current nga nagflow pinaagi sa dili gipangutana nga ruta uban wala resistance o impedance. Kini nagresulta og excessive current nga nagflow pinaagi sa circuit, nga makapadamage sa equipment o makapahimong electrical shocks sa mga tawo nga nabilin.
Ang dead short mahadlok pangitaon ug diagnose tungod kay ang current nagbuild rapido ug nagtrip sa breaker kaagad.
Kini kasagaran nahitabo tungod sa direct connection tali sa positive ug negative power wires o direct connection tali sa positive wire ug ground.
Ang dead shorts labi na dangerous tungod kay kini nagcausa og high amount of current nga magflow pinaagi sa circuit.
Arigaton ang difference tali sa dead short ug short circuit, atong pilian ang example. Pagsabot ang voltage difference tali sa duha ka puntos mao ang 150 V.
Kon mi-measure nato ang voltage tali sa duha ka puntos sa normal conditions, kini moshow 150 V. Apan, kon ang voltage tali sa duha ka puntos mas bata sa 150 V, kini gitawag og short circuit.
Ang some voltage drop mosulay sa short circuit, ug may resistance nga mosulay tali sa duha ka puntos.
Kon ang measured voltage mao ang 0 V, kini gitawag og dead short. Kini nangulto nga zero resistance sa circuit.
Ang difference tali sa normal condition, short-circuit, ug dead-short gisulti sa figure sa ubos.
Ang bolted fault gitawag usab og fault nga zero impedance. Kini nagproduce og extreme fault current sa system.
Kon tanang conductors gi-connect sa ground pinaagi sa metallic conductor, ang fault gitawag og bolted fault.
Ang bolted fault (bolted short) sama ra sa dead short. Kon sa dead short, ang resistance zero.
Ang ground fault mosulay sa power system kon ang hot wire (live wire) accidental connect sa earth wire o grounded equipment frame.
Sa kondisyon kini, ang frame sa equipment energies sa dangerous voltage. Sa ground fault, adunay some amount of ground resistance present. Ug ang fault current depende sa ground resistance.
Tungod niini, ang ground fault lain sa dead short.
Arigaton ang dead short, atong pilian ang example. Pagsabot ang network nga adunay three resistors connected in series, as shown in the figure below.
Sa normal conditions, ang current passes through the circuit are I ampere. Ug ang total resistance sa circuit REQ.
REQ=5+15+20
According to ohm’s law;