
Para sa pagdala sa overhead line, gigamit ang kayong poste, beton poste, bakal poste ug rail poste. Ang mga poste nga gigamit depende sa importansya sa load, lugar, kostos sa konstruksyon, kasama ang maintenance cost, ug panalipod sa profit. Sa low voltage line para sa tanang phase, natural ug earth, gigamit nato ang single pole line. Adunay daghang klase sa poste nga gigamit sa electrical system. Ania ang mga poste:
Kayong Electric Poste
Beton Electric Poste
Bakal Tubular Electric Poste
Rail Electric Poste
Sa mas naunang panahon, gigamit ang kayong poste para sa 400 volts ug 230 volts L.T. line ug 11 K.V. H.T. line sa dako. Sa pipila ka okasyon, gigamit usab ang kayong poste para sa 33 KV line. Ang cost-effectiveness sa kayong poste mas mubo kumpara sa uban nga electric poste ug ang gasto sa foundation mas mubo usab. Kon maayo nga gi-maintain ug gi-treat ang kayo, ang kayong poste mahimong maglast long period.

Konsekwensiya niini, sa mas naunang panahon, dako kaayo ang paggamit sa kayong poste. Ang shaal wood adunay labi nga kalidad sa kayo para sa electric poste. Ang average weight sa 'shaal' wood mao ang 815 kg per cubic meter. Apart sa Shaal, Masua, Tik, Chir, Debdaru woods usab gigamit alang sa purpose batas sa availability. Sa kasagaran, aron protektahan ang mga forest, maintain ang ecological balance, ang paggamit sa kayong poste mao na almost stopped. Ang kayong poste gitibuok sa tulo ka klase batas sa ilang capacity sa pagbear sa load sa electric conductors.
Ang breakdown force mao ang above 850 Kg/cm2. Examples are Shaal, Masua wood, etc.
Ang breakdown force mao ang between 630 Kg/cm2 ug 850 Kg/cm2. Examples are Tik, Seishun, Garjan wood, etc.
Ang breakdown force mao ang between 450 Kg/cm2 ug 630 Kg/cm2. Examples are Chir, Debdaru, Arjun wood etc.
Ang kayo nga gigamit para sa electric poste dapat walay defect. Ang straight kayo mas preferable. Kon wala ta makita og fully straight kayo sa length nga walay defect, ang bit curved kayo acceptable usab. Kon needed, duha ka short length poles mahimo mog joint together para mouban.
Ang seasoning sa kayo ang unang buhaton. Iyang nanginahanglan, drying ang kayo maayo. Ang mushroom mahimo mog damage sa kayo ug termites mahimo og maximum damage sa kayo. Tungod sa heat ug moisture, ang kayo madamage. Ang matang sa poste below o nearby sa ground level ang kadaghanan sa damage. Para protektahan sa moisture ug termite, proper chemical treatment gihimo sa kayo. Para maayo nga maintenance, Tar mixed with Creojet Oil or Copper Crom Arsenic gigamit. Ang sunod nga treatment mao ang Askew treatment. Sa proseso, ang mga poste gisulob sa cylindrical air sealed tank. Sa tank, ang mga poste gisulob sa Copper Crom Arsenic chemical. 100 kg per square meter pressure gihimo sa tank at least para sa usa ka oras. Tungod sa high pressure, ang chemical mobati sa pores sa kayo. Konsekwensiya, ang moisture ug termites dili mog attack sa kayo sa dako nga panahon.
Kon tungod sa bisan unsa nga rason ang kayo wala maayo nga treat, bago i-erect ang poste, duha ka coats of Creojet oil is apply sa entire surface sa poste. Bituminous Creojet Oil, is apply sa portion sa soil as well as up to 50 cm or 20 inches above the soil. Kon wala possible, at least tar must be applied on such surface of the pole. Kon wala possible ang treatment, at least burn the bottom outer surface of the pole up-to two meters to prevent the pole from termite and moisture.
Ang top of the pole should be cut into a sharp cone shape so that water cannot stay on the top of the pole. Then we cut proper grooves as per required in the upper portion of the pole to fit cross arms tightly. We also drill holes on the pole for the same purpose. The diameter of the drilled hole varies from 17 mm to 20 mm. To fit, D-shaped iron clamp, grooves are not necessary, drilled hole in the required distance is sufficient. The distance between the top hole and top tip of the pole should be at least 200 mm or 8 inches. All such hole or grooves should be created before the treatment. One should avoid doing such holes and grooves on the pole, once the pole is treated. If we make holes or grooves after the treatment, we must apply creosote oil or bitumen on those holes and grooves.
Adunay duha ka tipo sa beton poste:
R.C.C. Poste
P.C.C. Poste
Karon P.C.C. poste gigamit sa 11 KV ug 400/230 volt system sa dako, apart sa this, gigamit usab ang PCC poste sa 33KV H.T. Line. Ang tipo sa poste mas mahal kaysa kayong poste pero mas barato kaysa bakal poste. Ang tipo sa poste adunay mas dako nga life, ug ang maintenance cost walay bahin. Ang strength sa PCC Poste mas dako kaysa kayong poste pero mas gamay kaysa bakal poste. Ang disadvantage lang niini mao ang heavy ug breakable.

Ang beton electric poste gihimo sa cement concrete. Para mapataas ang strength, gigamit nato ang iron bars or rods reinforcement sa concrete. Para sa earthing purpose, kita mosulob og copper strip sa size 25mm × 3mm sa loob sa poste during concreting, o kita mosulob og hollow channel sa poste para sa pag-insert sa earthing wire. Para fix different fittings sa poste as required kita mosulob og 20 mm diameter holes sa poste during concreting.
Ang cross-section sa poste mas dako sa bottom kaysa sa top. Ang cross section sa PCC poste rectangular, dili square.
Batad sa lateral load capacity ug height sa poste, ang beton poste gitibuok sa 11 classes