EMF Equation of Transformer

Encyclopedia

Field: Encyclopedia

China

EMF Equation of Transformer Definition

The EMF equation of a transformer is derived using Faraday’s law, indicating the induced EMF based on flux changes and winding turns.

Magnetizing Current

An alternating current in the primary winding generates a magnetizing current that produces alternating flux in the transformer’s core.

Sinusoidal Flux and EMF

The sinusoidal primary current creates a sinusoidal flux, and its rate of change (cosine function) determines the induced EMF.

Voltage and Turns Ratio

The ratio of primary to secondary voltage (voltage ratio) is directly proportional to the ratio of the number of turns in the primary and secondary windings (turns ratio).

Transformation Ratio

The transformation ratio (K) indicates whether a transformer is step-up (K > 1) or step-down (K < 1), based on the primary and secondary windings.

Give a tip and encourage the author!

Topics:

Machines

Transformers

Transformer EMF Equation

About experts

Encyclopedia

China

Recommended

Top 5 Faults Found in H61 Distribution Transformers

Five Common Defects of H61 Distribution Transformers1.Lead Wire DefectsInspection Method: The three-phase DC resistance imbalance rate significantly exceeds 4%, or one phase is essentially open-circuited.Remedial Measures: The core should be lifted for inspection to locate the defective area. For poor contacts, re-polish and tighten the connection. Poorly welded joints should be re-welded. If the welding surface area is insufficient, it should be enlarged. If the lead wire cross-section is inade

Felix Spark

12/08/2025

What lightning protection measures are used for H61 distribution transformers?

What lightning protection measures are used for H61 distribution transformers?A surge arrester should be installed on the high-voltage side of the H61 distribution transformer. According to SDJ7–79 "Technical Code for Design of Overvoltage Protection of Electric Power Equipment," the high-voltage side of an H61 distribution transformer should generally be protected by a surge arrester. The grounding conductor of the arrester, the neutral point on the low-voltage side of the transformer, and the

Felix Spark

12/08/2025

How to Select H61 Distribution Transformers？

H61 Distribution Transformer Selection includes the selection of transformer capacity, model type, and installation location.1.Selection of H61 Distribution Transformer CapacityThe capacity of H61 distribution transformers should be selected based on the current conditions and development trends of the area. If the capacity is too large, it results in the “large horse pulling a small cart” phenomenon—low transformer utilization and increased no-load losses. If the capacity is too small, the tran

Echo

12/06/2025

110kV Transformer Zero-Sequence Protection: Issues & Improvement Measures

Problems with Zero-Sequence Protection of 110 kV TransformersIn an effectively grounded system, the neutral-to-ground displacement voltage of a transformer is limited to a certain level, and the neutral-point gap protection does not operate. The purpose of installing gap protection is to prevent damage to transformer insulation caused by elevated zero-sequence voltage in non-effectively grounded systems. The discharge gap only operates when a single-phase ground fault occurs, all directly ground

Echo

12/03/2025