Mahimo ang pag-convert sa alternating current ngadto sa direct current walay paggamit og bateria o transformer. Mahimong gamiton ang rectifier alang niining kalihukan.
I. Prinsipyo sa pagtrabaho sa mga rectifier
Ang rectifier mao ang electronic device nga mahimo ang pag-convert sa alternating current ngadto sa direct current. Mainly nato mahimo ang pag-rectify pinaagi sa unidirectional conductivity characteristics sa semiconductor devices sama sa diodes.
Half-wave rectification
Sa half-wave rectifier circuit, kon present ang positive half-cycle sa input alternating current, ang diode mag-conduct, ug ang current mag-flow through the load, formon usa ka direct current output. Sa negative half-cycle sa input alternating current, ang diode gi-cut off, ug walay current nag-flow through the load. Pinaagi niini, makakuha tayo og pulsating direct current na may positive half-cycle lang sa output. Pananglitan, ang simple half-wave rectifier circuit mahimo kini gikan sa diode ug load resistor.
Ang advantage sa half-wave rectification mao ang simple ug low-cost ang circuit. Apan ang disadvantage mao ang dako kaayo ang fluctuation sa output direct current voltage, ug lawas ra ang efficiency, gamiton ra ang half sa alternating current waveform.
Full-wave rectification
Ang full-wave rectifier circuit mahimo mosugyot sa mga shortcomings sa half-wave rectification. Gigamit niini ang duha ka diodes o center-tapped transformer aron ma-pass ang both positive ug negative half-cycles sa alternating current through the load, resulta adunay mas smooth nga direct current output. Pananglitan, sa full-wave bridge rectifier circuit, apat ka diodes formon usa ka bridge. Wa pa unsa ang input alternating current, either positive half-cycle o negative half-cycle, adunay duha ka diodes mag-conduct, ug current always mag-flow through the load.
Ang full-wave rectification adunay mas taas nga efficiency ug less fluctuation sa output direct current voltage, apan mas complex ang circuit.
II. Uban pang posible nga mga paraan
Sumala sa rectifiers, uban pang mga paraan mahimo usab sa pag-convert sa alternating current ngadto sa direct current, apan ang mga paraan niini kasagaran gigamiton usab ang specific electronic components.
Capacitor filtering
Ang pag-connect og capacitor in parallel sa output end sa rectifier circuit mahimo mosugyot sa filtering role ug mas smooth ang output direct current. Kon present ang peak voltage sa input alternating current, ang capacitor mag-charge; kon bumaba ang input voltage, ang capacitor mag-discharge aron maintain ang voltage across the load. Pananglitan, sa simple half-wave rectifier circuit nga may capacitor filtering, ang capacitor mahimo mosugyot sa pag-reduce sa fluctuation sa output voltage.
Ang filtering effect sa capacitor depende sa capacitance sa capacitor ug sa size sa load. Generally speaking, ang mas dako ang capacitance, mas maayo ang filtering effect, apan mas taas usab ang cost.
Voltage stabilizing circuit
Arong mas stable ang output direct current voltage, mahimo mogdag-on og voltage stabilizing circuit sa basehan sa rectifier circuit ug filtering circuit. Ang voltage stabilizing circuit mahimo mosugyot sa automatic adjustment sa output voltage sumala sa change sa load aron maintain sa relatively stable range. Pananglitan, ang commonly used voltage stabilizing diodes, three-terminal voltage regulators, etc. mahimo mosugyot sa construction sa voltage stabilizing circuit.
Ang voltage stabilizing circuit mahimo mosugyot sa quality sa direct current ug suitable sa occasions nga high requirements sa voltage stability.
In conclusion, kon walay battery o transformer, mahimo ang pag-convert sa alternating current ngadto sa direct current pinaagi sa rectifiers, combined sa capacitor filtering ug voltage stabilizing circuits.