RWK551 Single Tool is FTU PC maintenance software with no primary electrical parameters (voltage/current, lightning impulse, short-time withstand, making). It uses RS485 & RJ45 for FTU configuration and debugging.
Installation‑free standalone FTU maintenance tool, login via RS485/RJ45, Chinese‑English bilingual, supports IEC101, IEC104, DNP3.0. It realizes config upload/download, signal/meter/control point setting, real‑time monitoring & packet capture for field commissioning. The software follows corresponding IEC communication protocols.
RWK-35: Advanced 200mA SEF Recloser Controller compliant with ANSI C37.60. Smart brain for 12kV-38kV grid automation with DNP3.0/IEC104 multi-protocol support.
The Automatic Recloser Controller (with FA) is a crucial device in electrical systems. It ensures rapid re - closing of circuits after faults, enhancing power supply reliability.
The Line Sectionalizing Load Break Switch Controller is a key device. It manages the sectionalizing of power lines, ensures reliable power distribution, enhancing grid stability and operational safety
It is installation‑free standalone FTU maintenance PC software. It can configure, debug and operate FTU on‑site without network, automatically test communication protocols, which is very suitable for field commissioning work.
Supports RS485 serial port and RJ45 network port for login. Default username: admin, default password: 123. It provides Chinese and English language switch on login page.
Supported protocols include IEC101, IEC104 and DNP3.0. For IEC101 protocol, balanced mode is set as default, baud rate default value is 9600.
Login
